Product Introduction

Terminal block connection: Use cable 135101-XXXX-XX to connect the I/O module to external devices via

the terminal block.

Channel connection: Connect the wires of channel 1 and channel 2 to the external terminal block (PRST1/COM

and PRST2/COM are connected to external switches). Used to reset the following parameters: recorded peak

speed, number of reversals, peak reversals speed (PRST1 only).

Type of wiring board

Tachometer external wiring board: used to connect sensors and recorders.

Bus tachometer external terminal block: used to connect all three tachometer modules.

Recorder external wiring board: used to connect the recorder.

Usage scenarios

This external termination block is mainly used for TMR I/O discrete or TMR I/O bus configuration.

The specific configuration method is as follows:

TMR I/O Discrete: Each channel is connected to three sensors, and each sensor sends a signal to a

tachometer module. Three terminal blocks are required: two for sensors and one for recorder 1.

TMR I/O bus: Each channel is connected to two sensors, which are shared by all three tachometer modules.

Four external wiring boards are required: one for sensors and three for recorders

Many products have not been listed yet. Please contact us for more products If there is any

inconsistency between the product modeland the displayedpicture,the model shall prevail.

Please contact us for specific product pictures, and we will arrange for photos to be taken in the warehouse for confirmation

Technical Team Service Hotline：0591-85299001